Logo

SeaStar Sterndrive Steering: Order Guide

5-2
Selection Guide
SYSTEM
CONFIGURATION
COMPONENT QTY MODEL PART PAGE
DESCRIPTION REQ # REF #
SINGLE & DUAL STERNDRIVE
(For dual sterndrive applications use
engine manufactures supplied tie bar.)
CYLINDER 1 SEE APPLICATION GUIDE
HELM 1*SEASTAR (SEE NOTE 1) HH5271-3 6-6
** SEASTAR (SEE NOTE 2) HH5272-3 6-6
OIL 3 SEASTAR OIL HA5430 10-1
TUBE/HOSE SEE NOTE 3 9-7
FOR EXTRA STEERING STATION ADD:
HELM 1*SEASTAR (SEE NOTE 1) HH5271-3 6-6
** SEASTAR (SEE NOTE 2) HH5272-3 6-6
FITTING KIT 1 ADD A STATION
- FOR USE WITH SEASTAR
STEERING "HOSE" HF6007 9-13
- FOR USE WITH SEASTAR
TUBE/COPPER HF6010 9-14
OIL 1 SEASTAR OIL 10-1
EXTRA TUBE/HOSE SEE NOTE 3 9-7
Order Guide
OPTIONAL EQUIPMENT
BACK PLATE KIT (FOR STANDARD HELMS) HA5418 6-3
20 DEGREE WEDGE KIT (FOR STANDARD HELMS) HA5419 6-3
AUTOPILOT FITTING KIT
(FOR USE WITH SEASTAR HOSE)
HF6007 9-13
(FOR USE WITH SEASTAR TUBE/COPPER)
HF6010 9-14
POWER ASSIST STEERING PA1200-2 7-1
* ALL HELM DESIGNS CAN BE USED, SEE PAGE 6-1 FOR OPTIONS.
1. SeaStar helms are the standard
recommendation for both non-power and
power steered applications.
2.
SeaStar helms with a higher displacement
can be specified for less wheel turns
where faster response is desired.
Consult chart on page 5-3 for options.
3. * To ensure performance, select the
appropriate tube/hose kit as noted below
A) For SeaStar 1.7 Helms: use SeaStar
3/8" Extruded Nylon tubing, part # HT5xxx.
B) For SeaStar 2.0, 2.4 or 2.0 helms:
use SeaStar/SeaStar PRO Outboard
Steering Hose, or, 3/8" diameter copper
tube and copper tube hose kit HF5508
(Refer to page 9-7 for details).
4. For dual stern drives use the tie bar
supplied by the engine manufacturer.
NOTICE
These recommendations apply to
factory stock stern drives only.
Modified installations and high
performance applications may
require a higher capacity steering
system. If in doubt, contact our
technical service for assistance.
STERNDRIVE STEERING