Logo

SeaStar Outboard Front Mount: Cylinder Installation, General Dimensions & Replacement Parts

SEASTAR and BAYSTAR Hydraulic Steering Systems
3-9
OUTBOARD–FRONT MOUNT
(67mm)
3/8" COMPRESSION FITTING FOR
HOSE CONNECTION
4 7/8"
(124mm)
2 5/8"
21 3/4"
(552mm)
BLEED NIPPLE
PIVOT PLATE
Typical HO6001 tiebar
installation shown
WARNING
Cylinder Installation, General
Dimensions & Replacement Parts
# OF A B C MIN. ENGINE
ENGINES CENTER DISTANCE
1 22" (559mm) 6" (152mm) 5" (127mm) N/A
2 49" (1244mm) 6" (152mm) 5" (127mm) 26" (660mm)
NOTES
a) Dimensional restrictions also apply to external motor mount brackets.
b) Maximum engine center distance for twin engine applications is 36" (914mm)
using the standard tiebar. Dimension 'A' would have to be increased
proportional to the tiebar length.
c) Minimum engine center distance is 26" unless engine manufacturer
recommendation is greater.
d) Splashwells of less than 30" in overall width may require engine removal in
order to install and service the support rod.
Motor Well dimensions required for front
mount outboard steering systems
A
Operational interference of the steering cylinder/cylinder
fittings and jackplates/transom/splashwell can occur under
certain conditions. Check installation thoroughly throughout
the full range of Motor Tilt, Jackplate Height and Trim before
making final installation.
If interference is not eliminated total steering loss can occur,
causing property damage and/or personal injury.
ALL Front Mount Cylinders
C
B
NOTICE
Pivot plate dimensions vary
depending on exact cylinder
model.
SEAL KIT = HS5157
SUPPORT BRACKETS = HP6018
SUPPORT ROD = HP6016
SPACER KIT = HP6033
HOSE ELBOW FITTING = HF6004
PIVOT PLATE = N/A (cylinder replacement/
repair is required)