Logo

BayStar Outboard Steering: Front Mount (Cont.)

SEASTAR and BAYSTAR Hydraulic Steering Systems
1-3
3) Is there enough room in the splashwell for full engine tilt?
Find the dimensions (B & C) of your splashwell. Check them
against the minimum splashwell dimensions for full engine tilt
for your engine and cylinder.
MOTOR WELL DIMENSIONS required for BayStar front mount outboard steering systems
A
C
B
i) Ensure there is no interference between the
BayStar cylinder rod and the splashwell boot
or engine controls & cables.
ii) Dimensional restrictions also apply to
external motor mount brackets.
iii) Ensure dimension 'A' maintained through full
trim/tilt range.
iv) Maximum transom thickness 3" (76mm).
v) Engines less than 70HP may
require up to
an additional 1" (25mm) of splashwell
clearance.
2) Is the Splashwell wide enough? The HC4645H/47H/48H/58H
require a minimum 21" (534mm) Splashwell width.
BAYSTAR CYLINDER PART# HC4645H/47H/48H/58H
2.625"
(67mm)
21" (534mm)
CYLINDER # OF A B C
MIN. ENGINE
MODEL NO.
ENGINES
CENTER DISTANCE
HC4645H/47H/ 1 21" (534mm) 6" (153mm) 5" (127mm) N/A
2 Twin engine applications not available at this time
NOTES:
42°
1
2
3
4
5
9.2" (233.5 mm)4.8" (122 mm)
6.8" (173 mm)
1.3" (33 mm)
3" (76 mm)
3.5" (89 mm)
3.6" (91.5 mm)
ORB PORTS (4)
2.4"
(61 mm)
SPORT PLUS TILT HELM PART# HH4316-3 HH4315-3 (1.4 cu.in.) Gives 5.2 wheel turns lock to lock.
NOTICE
Comes with
newly designed tilt
mechanism.
SEAL KIT = HP6032
TILT MECHANSIM KIT = HA6423
SEAL KIT = HP4600 TEE/BLEEDER KIT = HF4202 SUPPORT ROD/NUT/CLIP = /HP6050 PIVOT PLATE SEE PAGE1-5
OUTBOARD–FRONT MOUNT