| Author |
Message |
    
reytumamao
| | Posted on Tuesday, January 21, 2003 - 09:11 pm: | 
|
Hello, I would like some help on removing an impeller on a johnson 30hp and would like to know how to check if thermostat is working
thanks
Rey |
Rick
| | Posted on Tuesday, January 21, 2003 - 09:14 pm: |
|
Rey,
I could explain this to you in detail, but If you have no idea, I would recommend you purchase a service manual. This will give you full details on this and many other common procedures required to properly maintain your motor. Good luck.
Rick |
sparky
| | Posted on Tuesday, January 21, 2003 - 10:50 pm: |
|
Post the model #, there are some differences. |
Monty
| | Posted on Saturday, May 22, 2004 - 02:30 pm: |
|
Hello, I have a 1999 50 HP Honda 4 stroke outboard motor. The overheat warning is coming on. There is a steady stream of water flowing out of the motor, but not high pressure. The water is pretty warm. Do you think it is a bad sensor or a bad impeller? Can you send me a drawing or tell me where the impeller and sensor are?
Thanks,
Monty |
|
