MarineEngine.com - Your best connection for marine engines, parts, service, and information. View Cart / Check Out Contact MarineEngine.com Ordering and Shipping Information Free Engine Classifieds Engine Parts Discussion Board Engine Manuals Home / Directory
add bookmark or favorites | email this page
Topics Topics Edit Profile Profile Help/Instructions Help Member List Register  
Search Last 1|3|7 Days Search Search Tree View Tree View  

96 Mariner 200efi Having light and bu...

Discussion Forum at MarineEngine.com » Archive of all topics » Outboard motors archive » 2002 July - Sept » 96 Mariner 200efi Having light and buzzer problems. « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

randy
Posted on Tuesday, July 09, 2002 - 03:02 pm:   Edit Post Delete Post View Post/Check IP

I own a 96 Mariner 200efi outboard. I having problems with the lights and buzzers going off. The warining lights that are going off is the low or no oil and the other is overheating light. I have replace the low oil sender and the oil pickup sender. I have also clean the grounds on the engine. My engine is not reaching the suggested rpms it only revs to thousand.I check all my oil lines and I don't see any damage or air bubbles in them.I don't know why my overheating light comes on when I first start the engine. If I was to put a temp gun on the head , what should it be at.
randy
Top of pagePrevious messageNext messageBottom of page Link to this message

bob
Posted on Tuesday, July 09, 2002 - 05:22 pm:   Edit Post Delete Post View Post/Check IP

i have the same problem on my 175 yamaha, heres what to try..tilt your motor up, and let the oil reserve on the motor drain for a few days, then come back and put the motor in the water and wait a few minutes before starting, that should stop the lights from going off because that tank on the motor has had time to fill up..the other thing i did was take the oil line going to the engine, and put a check valve in it, so the oil doesnt leak back down into the main tank.. i dont know if this will work for you, but its worth a try.. good luck and let us know.
Top of pagePrevious messageNext messageBottom of page Link to this message

Tonyob (Tonyob)
Posted on Tuesday, July 09, 2002 - 05:36 pm:   Edit Post Delete Post View Post/Check IP

Randy,

If you measure the temp at the head it should be around 160-180 degrees.

Tony

Administration Administration Log Out Log Out   Previous Page Previous Page Next Page Next Page


Home / Directory | Engine Manuals | Engine Parts | Discussion Board | Free Classifieds | Orders / Shipping | Contact Us | View Cart

About Us | Terms of Use | Privacy Policy
MarineEngine.com, 184 Jones Dr., Brandon, VT 05733 USA
Phone: 802-247-4700 FAX: 802-301-1034 info@marineengine.com
Copyright © 2000 - 2007 by MarineEngine.com, Inc. All rights reserved
   
Traduca
EspanolEspanol
Traduisez
FrancaisFrancais
Traduza
PortuguesePortuguese
Traduca
Italiano
Ubersetzen
Deutschen
  
Sierra Marine Catalog
Seloc Online Manuals
Product Categories
Engine Parts · By Brand
Engine Manuals · By Brand
Books
General Repair and Maint.
Care and Repair
· Adhesive and Sealants
· Bottom Cleaners
· Cleaners Wax and Polish
· Mops Brushes and Sponges
Covers and Tops
· Bimini Tops   · Hardware
· Cover Accessories
· Motor Covers
· Universal Boat Covers
Electronics
· Gauges and Compasses
· Mounts and Accessories
Electrical
· Batteries & Chargers
· Battery Accessories
· Dockside Electrical
· Electrical Terminals
· Electrical Wire, Cable
· Fuses, Fuse Holders
· Switches
· Wire Ties, Clips, Tape
Fuel Systems
· Fuel Tanks
· Fittings, Fills, Vents
· Hose & Primer Bulbs
· Filters, Senders, Caps
Hardware
· Deck Cabin Hardware
· Molding and Rub Rails
· Rails and Fittings
· Snaps Shackles and Hooks
· Windshield Hardware
Lighting
· Cabin Lights · Light Bulbs
· Navigation Light Parts
· Navigation Lights
· Spotlights   · Parts
Mooring and Dock
· Boat Fenders · Boat Hooks
· Buoys and Markers
· Deck Cleats · Dock Edging
· Dock Parts and De-Icers
· Fender Covers and Holders
· Keelshield / Toon-Tectors
· Ladders and Platforms
Prop / Trim / Transom
· Jack Plates, Wedges
· Mounting Brackets
· Outboard Stands
· Trim Tabs, Stablizers
· Prop Nuts, Locks, Pins
 · Propellers · Wrenches
Pumps
· Aerator Pumps
· Bilge Pumps
· Drain Plugs and Tubes
· Hose · Through Hull Fittings
Rope and Cordage
· Anchor Line   · Dock Line
· Fender Line   · Bulk Rope
· Shock Cord and Bungee
Safety Products
· Horns Bells and Whistles
· Mirrors
· Vents Blowers and Hose
Sanitation
· Fresh Water Pumps
· Marine Toilets
· Sanitation Chemicals
· Sanitation Pumps/Hose
· Water/Waste System Parts
Seating
· Deck Chairs and Tables
· Fishing Seats
· Lounge Seats
· Pontoon Furniture
· Seat Bases and Pedestals
Steering / Control
· Control Boxes
· Control Cables
· Hydraulic Steering
· Mechanical Steering
· Rigging · Steering Wheels
Tools / Shop Supplies
· Lubricants & Additives
· Motor Flushers
· Tools & Test Equipment
Trailering
· Boat Guides/Motor Support
· Hitches Balls Couplers
· Rollers Brackets Springs
· Tires Wheels and Carriers
· Trailer Hubs & Bearings
· Trailer Jacks
· Trailer Wiring and Lighting
· Winches Straps Tie Downs
 Manufacturer List