|
| Author |
Message |
    
John S McGolrick
New member
Username: john_s_mcgolrick
Post Number: 1
Registered: 04-2009
| | Posted on Friday, April 03, 2009 - 06:33 pm: | 
|
The motor was not running so I replace the points in this seaking Set the point at .021. Motor will start! but not run. Good compression,sometimes if I am fast, I can throw it in gear, and full throttle, the motor will run until I back off any suggestion |
Bob Caskey
Advanced Member
Username: bobbyc
Post Number: 291
Registered: 10-2007
| | Posted on Friday, April 03, 2009 - 09:37 pm: |
|
Rebuild the carburetors |
|
|
