|
| New boat construction re: Transom thi... |
| Author |
Message |
    
TBMatz
New member
Username: beemerguy
Post Number: 1
Registered: 03-2009
| | Posted on Friday, March 20, 2009 - 10:55 pm: | 
|
I am embarking on a project boat for my BMW 220 I/O and have my construction details down as to frame, chines, materials, transom angle etc but would like a bit of info on transom thickness and desired material. This is a wooden hull from start to finish. Frame and chines is oak, bottom is 3/4 in press. treat. ply. rest is mahogany ply. |
Bondo
Senior Member
Username: bondo
Post Number: 1784
Registered: 12-2006
| | Posted on Saturday, March 21, 2009 - 12:49 pm: |
|
Ayuh,...
I know Nothing about Beemers, but Everybodyelse uses a 2" transom thickness.... |
TBMatz
New member
Username: beemerguy
Post Number: 2
Registered: 03-2009
| | Posted on Saturday, March 21, 2009 - 01:16 pm: |
|
Thanks. I will use that as was thinking of two laminated (glued) pieces of 3/4 in marine ply but can add another 1/2 in mah. on outside to bring up to 2 in. and have finished appearance to boot rather than planned epoxy paint finish. Mahogany grain with marine spar finish much better.
First time project like this and that's why I am in here....advice...Thanks again Bondo, sounds good. Beemer in Ontario |
|
|
|
Product Categories |
| Engine Parts · By Brand |
| Engine Manuals · By Brand |
| Books |
| General Repair and Maint. |
| Care and Repair |
| · Adhesive and Sealants |
| · Bottom Cleaners |
| · Cleaners Wax and Polish |
| · Mops Brushes and Sponges |
| Covers and Tops |
| · Bimini Tops · Hardware |
| · Cover Accessories |
| · Motor Covers |
| · Universal Boat Covers |
| Electronics |
| · Gauges and Compasses |
| · Mounts and Accessories |
| Electrical |
| · Batteries & Chargers |
| · Battery Accessories |
| · Dockside Electrical |
| · Electrical Terminals |
| · Electrical Wire, Cable |
| · Fuses, Fuse Holders |
| · Switches |
| · Wire Ties, Clips, Tape |
| Fuel Systems |
| · Fuel Tanks |
| · Fittings, Fills, Vents |
| · Hose & Primer Bulbs |
| · Filters, Senders, Caps |
| Hardware |
| · Deck Cabin Hardware |
| · Molding and Rub Rails |
| · Rails and Fittings |
| · Snaps Shackles and Hooks |
| · Windshield Hardware |
| Lighting |
| · Cabin Lights · Light Bulbs |
| · Navigation Light Parts |
| · Navigation Lights |
| · Spotlights · Parts |
| Mooring and Dock |
| · Boat Fenders · Boat Hooks |
| · Buoys and Markers |
| · Deck Cleats · Dock Edging |
| · Dock Parts and De-Icers |
| · Fender Covers and Holders |
| · Keelshield / Toon-Tectors |
| · Ladders and Platforms |
| Prop / Trim /
Transom |
| · Jack Plates, Wedges |
| · Mounting Brackets |
| · Outboard Stands |
| · Trim Tabs, Stablizers |
| · Prop Nuts, Locks, Pins |
| · Propellers · Wrenches |
| Pumps |
| · Aerator Pumps |
| · Bilge Pumps |
| · Drain Plugs and Tubes |
| · Hose · Through Hull Fittings |
| Rope and Cordage |
| · Anchor Line · Dock Line |
| · Fender Line · Bulk Rope |
| · Shock Cord and Bungee |
| Safety Products |
| · Horns Bells and Whistles |
| · Mirrors |
| · Vents Blowers and Hose |
| Sanitation |
| · Fresh Water Pumps |
| · Marine Toilets |
| · Sanitation Chemicals |
| · Sanitation Pumps/Hose |
| · Water/Waste System Parts |
| Seating |
| · Deck Chairs and Tables |
| · Fishing Seats |
| · Lounge Seats |
| · Pontoon Furniture |
| · Seat Bases and Pedestals |
| Steering / Control |
| · Control
Boxes |
| · Control
Cables |
| · Hydraulic
Steering |
| · Mechanical
Steering |
| · Rigging · Steering
Wheels |
| Tools / Shop Supplies |
| · Lubricants & Additives |
| · Motor Flushers |
| · Tools & Test Equipment |
| Trailering |
| · Boat Guides/Motor Support |
| · Hitches Balls Couplers |
| · Rollers Brackets Springs |
| · Tires Wheels and Carriers |
| · Trailer Hubs & Bearings |
| · Trailer Jacks |
| · Trailer Wiring and Lighting |
| · Winches Straps Tie Downs |
| Manufacturer List |
|
