| Author |
Message |
    
marty carroll
New member
Username: marty_carroll
Post Number: 1
Registered: 05-2008
| | Posted on Sunday, May 04, 2008 - 10:04 am: | 
|
I just received a 5 hp k5003108c made by clinton engines corp. The problem is no spark . how do you remove the cover to the coil wire.I removed the bolts and sprayed the shaft with wd40 but was afraid to applied to much pressure to the cover |
Graham Lamb
Senior Member
Username: galamb
Post Number: 3107
Registered: 05-2007
| | Posted on Sunday, May 04, 2008 - 10:53 am: |
|
Might be a little seized from sitting - a flywheel puller or even a steering wheel puller (if it will fit) will make the job easy.
Just don't try to "pry it" off. It needs equal pressure on both sides or you could break something... |
scott puffer
Member
Username: brim_buster
Post Number: 46
Registered: 01-2008
| | Posted on Monday, May 05, 2008 - 09:41 am: |
|
tap it gently with a piece of wood and a mallet and it should losen from the key way and pop up. tap it on the flywheel nut. |
marty carroll
New member
Username: marty_carroll
Post Number: 2
Registered: 05-2008
| | Posted on Monday, May 05, 2008 - 08:05 pm: |
|
Thanks for the tips .I removed the flywheel and cleaned it and checked the spark plug wire seems to be ok .Checked the coil with a ohm meter I have continuity. Put everything back together and still no spark.Where can I buy a condenser and coil if needed.I'll start with the condenser first. |
marty carroll
New member
Username: marty_carroll
Post Number: 3
Registered: 05-2008
| | Posted on Monday, May 12, 2008 - 05:53 pm: |
|
I HAVE A CLINTON 5HP MOTOR I HAVE GOOD SPARK BUT SHE WON'T TURN OVER. SPARK PLUG IS GETTING WET TO MUCH FUEL . WHAT WOULD THE SETTINGS BE ON THE CARB. 3 SET SCREWS ONE ON TOP ONE ON THE SIDE AND ONE ON THE BOTTOM OF THE BOWL PLEASE HELP |
