|
| Author |
Message |
    
Jeffrey l Williams
New member
Username: comanche61p
Post Number: 1
Registered: 09-2009
| | Posted on Tuesday, September 22, 2009 - 07:51 pm: | 
|
Does anyone have any idea where to get a correct temp sender? I have tried Stewart Warner and the same number 362 AH-D will not register on my gauge. I have replaced wiring, senders several times and tested the gauge and switch as well as grounds to no avail. I believe the resistance is different in the new sender than the original of the same number thus won't read correctly? Jeff Williams |
Dan Wentworth
Member
Username: danwentworth
Post Number: 7
Registered: 03-2009
| | Posted on Tuesday, September 22, 2009 - 08:34 pm: |
|
Couple of things:
- If you connect the gauge sender terminal to the gauge ground does the gauge register full hot? Every gauge I have worked with behaves this way regardless of the sender resistance range.
- Does the gauge have a solid 12 Volts at the gauge ignition terminal? A variance here can greatly affect your reading.
Dan |
|
|
