| Author |
Message |
   
Jim Cilley
Member Username: wndowhunt
Post Number: 8 Registered: 05-2008
| | Posted on Friday, June 05, 2009 - 11:28 am: |
|
anybody know where the vacume advance hooks to the carb or manifold on a 188 grey with twin side draft carbs |
   
Cal Martell
Advanced Member Username: cal
Post Number: 164 Registered: 02-2004

| | Posted on Friday, June 05, 2009 - 04:45 pm: |
|
If you have the carb setup off the engine there should be a port under the carb manifold closest to the distrib. Not on the carb but the manifold that the carb is bolted to. The brass tube runs under the carb to the dist, under the dist and bends around back to the advance mech. |
   
Jim Cilley
Member Username: wndowhunt
Post Number: 9 Registered: 05-2008
| | Posted on Saturday, June 06, 2009 - 01:05 pm: |
|
thanks cal is this in the tec manual |
   
Cal Martell
Advanced Member Username: cal
Post Number: 165 Registered: 02-2004

| | Posted on Saturday, June 06, 2009 - 04:06 pm: |
|
The pictures were from the tech manual but there is nothing in there that I found for vacuum advance. I just looked at my own engine to see the routing that I had. V8C 225, same 327 AMC block. Cal |