| Author |
Message |
    
Richard Conn
Visitor
| | Posted on Tuesday, May 23, 2006 - 10:13 pm: | 
|
I have a 1949 Gray Marine 4 cylinder Phantom Four-45 motor in my Penn Yan. I changed the oil to Pennoil multi vis. When I ran it after the oil change it was not getting any oil pressure. What could be the problem?? It runs fine but shows no oil pressure. I know that first I must check with a new oil pressure gauge but I know for sure that its not the gauge. What could be the problem? Oil Pressure releif stuck? Help. Rick Conn Boulder Colorado. email rickconn@comcast.net |
Fastjeff
Senior Member
Username: fastjeff
Post Number: 2321
Registered: 09-2003
| | Posted on Wednesday, May 24, 2006 - 07:48 am: |
|
Careful! You simply might not have gotten the pressure up yet--I assume you clicked her off immediately.
Here's what I would do: Pull the plugs. Rig up a a new mechanical pressure gage. Crank her over until (hopefully) the pressure comes up.
It might simply be a bad gage, but do not under any circumstances assume you can go boating this way.
Jeff |
Doug Kymer
New member
Username: dougk
Post Number: 2
Registered: 10-2007
| | Posted on Thursday, October 18, 2007 - 11:11 pm: |
|
Where do I find parts for a Gray Marine motor 4 Cyl I need a oil cap for the oil filler tube I will need other parts as I go along with the rebuild
Thanks
Doug |
Cal Martell
Member
Username: cal
Post Number: 83
Registered: 02-2004
| | Posted on Friday, October 19, 2007 - 12:16 am: |
|
That's an easy solve.
Gray Marine INC
310 North 6th Street
St Charles, IL 60174
630-485-5007
Fax 630-584-9141
Ask for Kim, they have the entire Gray Marine OEM parts inventory and are wonderful people to work with. They take phone orders if you have some part numbers or descriptions.
Cal |
