| Author |
Message |
    
Ken McMillan
New member
Username: sechelter
Post Number: 3
Registered: 10-2008
| | Posted on Sunday, April 05, 2009 - 12:43 am: | 
|
I'm trying to get the oil filter casing off my CN6 SD-33 in order to change the filter but can't budge the bolt holding it. My working space is very, very limited. I can get a socket (17mm) onto it but no room for the rachet. I can get a combination wrench on it but it won't move. Haven't tried vice grips yet as I don't want to mess up the head. Any suggestions? |
Ken McMillan
Member
Username: sechelter
Post Number: 4
Registered: 10-2008
| | Posted on Saturday, April 18, 2009 - 12:48 am: |
|
Found the right wrench to get it off! |
crzhors
Member
Username: crzhors
Post Number: 45
Registered: 09-2006
| | Posted on Saturday, April 18, 2009 - 11:22 pm: |
|
Howdy Ken, I went to a swap meet and got a remote filter adaptor and filter head for a $20,boy does this make oil filter changes a clean breeze, another happy SD22 operator, 1974 40'Challenger |
Ken McMillan
Member
Username: sechelter
Post Number: 5
Registered: 10-2008
| | Posted on Sunday, April 19, 2009 - 01:06 am: |
|
That's what I'm looking for now with not much success so far. Almost impossible to do an oil change without spilling oil into the bilge. |
Mike Fitzgerald
Member
Username: fitznooney
Post Number: 11
Registered: 01-2009
| | Posted on Friday, June 26, 2009 - 08:17 pm: |
|
Has anybody managed to source a remote filter adapter for the SD33 with the cannister filter, yet? |
