Return to MarineEngine.com's home page. Home Call MarineEngine.com or send an email message. Contact Info about orders, shipping and returns. Shipping/Returns View your shopping cart. Cart
Need help with your boat parts order? Call 800-209-9624 Monday - Friday 8:30 AM - 5:30 PM EST Order by phone (800) 209-9624
Monday - Friday 8:30 AM - 5:30 PM EST
Free Classifieds Discussion Forum
Topics Topics Edit Profile Profile Help/Instructions Help Member List Register  
Search Last 1|3|7 Days Search Search Tree View Tree View  

Tamd41 max 2000rpm first 2 min. then ...

Discussion Forum at MarineEngine.com » Volvo Penta Diesel » Archive through December 27, 2007 » Tamd41 max 2000rpm first 2 min. then full power « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Maynard Rupp
Visitor
Posted on Thursday, August 09, 2007 - 10:07 pm:   Edit Post Delete Post View Post/Check IP

Our 200hp Volvo TAMD 41 will only go to 2000 rpm for the first 2 min.even at full throttle. This occurs after starting either warm or cold. It is smooth. After 2 min. the RPM accelerates but not real quickly. 3750 rpm is now possible. Engine runs fine therafter until you stop for about 20 minutes, then the 2000 RPM limit occurs again.
Top of pagePrevious messageNext messageBottom of page Link to this message

Morten Ringvold
Senior Member
Username: haffiman37

Post Number: 2053
Registered: 04-2006


Posted on Thursday, August 09, 2007 - 11:04 pm:   Edit Post Delete Post View Post/Check IP

If You do not reach around 2400-2600 the turbo will not kick in.
The reason might be several, most common is bottom condition, wheight encrease of boat during season, prop profile change/dammage.
I take it for granted that the flters are clean and there is no fuel supply problem.
Top of pagePrevious messageNext messageBottom of page Link to this message

Maynard Rupp
New member
Username: maynardrupp

Post Number: 1
Registered: 08-2007
Posted on Friday, August 10, 2007 - 04:51 pm:   Edit Post Delete Post View Post/Check IP

We will check the prop...The engine is putting out white smoke at idle and up to the 2200 RPM point. Then brown smoke comes out and the engine accelerates to normal max rpm. Turbo seems to rotate smoothly. Sometimes when returned to idle, no white smoke. Engine now accelerates normally. If we see smoke, it hangs at 2200.
Top of pagePrevious messageNext messageBottom of page Link to this message

leovandersluijs
Visitor
Posted on Monday, August 13, 2007 - 05:40 pm:   Edit Post Delete Post View Post/Check IP

Hi Maynard,

It sounds like a problem with the injectors. There should be some diesel coming out of the exhaust with the cooling water also. This indicates that one or more injectors are defective.
But please check your fuelfilters first. Any problem with the supply will give a drop in RPM as well although this should not disappear after 20 minutes.

Good luck,
Leo
Top of pagePrevious messageNext messageBottom of page Link to this message

Axel Bigham
New member
Username: axel523

Post Number: 1
Registered: 08-2007
Posted on Tuesday, August 21, 2007 - 10:23 am:   Edit Post Delete Post View Post/Check IP

I have a AD41/DP. In neutral it will top out max RPM, in gear under a load it will not go past 2000 RPM. In neutral have bueish white exhaust, in gear under load black exhaust. Injector pump has been rebuilt. Turbo vanes are free. The gate in the exhaust is solenoid controled and I didn't see any change in its position whether in gear or in neutral. Any ideas.
Top of pagePrevious messageNext messageBottom of page Link to this message

ed van
Visitor
Posted on Sunday, November 18, 2007 - 06:33 am:   Edit Post Delete Post View Post/Check IP

hi,i've experienced the same for more than 10 yrs (AD31P & AD31L). engine compartment is probably poorly ventilated and/or engines slightly/nearly overpropped. A cold start always has a small power reduction because of the thicker oil. After a restart the temp of the air intake is initially much warmer than normal and the after cooler does not work 100%, both because the environment was warmed up during the resting period.

pls let me know if you got other advice that would make me change my mind.

Administration Administration Log Out Log Out   Previous Page Previous Page Next Page Next Page

Free Classifieds Discussion Forum
Home | Contact | Shipping/Returns | Cart
Boat Engine Parts Boat Motor Manuals Boat Accessories
About Us | Terms of Use | Privacy Policy MarineEngine.com, 184 Jones Drive, Brandon, VT 05733 USA
© 2009 MarineEngine.com, Inc. All rights reserved. Phone: 802-247-4700 | Fax: 802-301-1034 | eMail: info@marineengine.com