MD2B won't shut off

Author Message   Peter Shwonek New member Username: pshwonek Post Number: 1 Registered: 06-2009 Posted on Friday, June 05, 2009 - 01:40 pm:    I'm tryin' to find out just what needs the fixin'... My old MD2B will not shut down properly (I've been relegated to lifting the compression release levers). The throttle goes down to minimum, but turning any further and it starts speeding up again (i.e. it's not just a throttle adjustment issue). Has anyone seen this problem before? Are there any parts that might be worn out that would create this dilemma? Any thoughts at all would be super-appreciated! -Peter   Bob McKean New member Username: sybobcat Post Number: 2 Registered: 06-2009 Posted on Thursday, June 18, 2009 - 11:07 pm:    I had the same problem on a MD22P last week and found that a wire that connects to the fuel pump had slipped off. When reconnected the shut-off worked fine. This only applies to an electronic "engine stop" ...not a mechanical "pull lever" system. If yours is the latter type, check that the lever is connected to fuel pump.

Add Your Message Here Post: -Color- Black Red Green Blue Yellow Purple Orange Cyan Gray White -Font- Arial Courier Symbol Times Verdana -Size- Smallest (-2) Small (-1) Normal Large (+1) Largest (+2) Username: Posting Information: Only registered users may post messages here. Registration is FREE and easy, click on the REGISTER link at the top of the page. Thanks. Password: Options: Automatically activate URLs in message Action:

Administration Log Out   Previous Page Next Page