|
| TAMD 74-P EDC Metric or Imperial too... |
| Author |
Message |
    
Andy Nemier
New member
Username: nemier
Post Number: 1
Registered: 02-2008
| | Posted on Sunday, March 02, 2008 - 11:41 am: | 
|
Just bought the boat, but I'm away from it now and can't look at it.
I'm going to buy some tools before I go down to the boat. Will I need Metric or Imperial tools for these engines?
Can anyone recommend "Must Have" tools for these engines. So far, I only have the basics. |
DickV
Visitor
| | Posted on Monday, March 03, 2008 - 08:39 am: |
|
Standard metric set will work. Also 16-18 22 mm wrenches added. Set of metric allens also needed. |
Andy Nemier
New member
Username: nemier
Post Number: 2
Registered: 02-2008
| | Posted on Monday, March 03, 2008 - 04:48 pm: |
|
Thanks Dick. Appreciate it. I just spent 4 hours reading virtually every post here...When I get to my boat I will spend a few days doing a total Base Line Service on the Engines, and I'll report back here for the wash-up. I hope it's tears of joy & elation instead of just plain old tears... |
Andy Nemier
New member
Username: nemier
Post Number: 3
Registered: 02-2008
| | Posted on Sunday, May 10, 2009 - 11:45 am: |
|
Hi chaps, it's been awhile. I've been running the vessel for over a year now with no problems with the engines. I love my swedish twins! The swc impellers were a bitch to pull out, but other than that the running and servicing has ben great so far. |
|
|
