|
| VOLVO penta KAD44P EDC engines do not... |
| Author |
Message |
    
mbarak ahmed
New member
Username: mbarak_ahmed
Post Number: 1
Registered: 11-2007
| | Posted on Wednesday, November 21, 2007 - 11:59 pm: | 
|
I just bought a boat with two VOLVO penta KAD44P EDC engines and no drives (gear removed). The engines are in good condition, however I can not let them star.
I used new diesel and make sure it reach the nozzle (seams week), connect one battery and start one engine at a time.
It did not start from the Ignition key, engine does not rotate, so I put the key on on-position (gages and heater working) and start from the control box relay on the engine. The engine rotates but does not star-up.same result in both engines. I must have missed something!!!. Why it does not start from the key or relay? Is there any special thing for these engine types?. Any idea will be appreciated. |
DickV
Visitor
| | Posted on Wednesday, November 28, 2007 - 08:54 am: |
|
The engines must have complete system for operation.Controls, control panel, helm computer, harnesses,engine power train computer, gear solenoids or shift controls. Will not run without those components. |
mbarak ahmed
New member
Username: mbarak_ahmed
Post Number: 2
Registered: 11-2007
| | Posted on Wednesday, November 28, 2007 - 01:44 pm: |
|
thank you dickV, actualy everthing is in plase accept lower unit and one of the shift control.
i figur out how to start with key, but it does not fire. someone told me, it could be a program/computer setting that is messed sice i try to start manual!!!!. if this is the case, what is the remeady. |
|
|
