    
KURT KINGSTON
Member
Username: kurt_k
Post Number: 4
Registered: 09-2007
| | Posted on Wednesday, October 03, 2007 - 11:24 pm: | 
|
I was wondering if anyone had a recommendation on what type of gasket sealer to use on the cylinder head gasket and intake/exhaust manifold gaskets on my MD6?
I am planning on using Permatex Aviation Form-A-Gasket 3H with the brush on applicator.
Strange in my copy of the MD6A Engine Workshop Manual I have not found a single instruction about whether/what type to use other than a generic discussion on Loctite 574 (page 7) which I'm told is no longer available.
Any help is very much appreciated.
Kurt K. |
