|
| 7.4 Marine Power Problem Please Help! |
| Author |
Message |
   
Larry Jeffries
New member Username: ljeffries
Post Number: 1 Registered: 09-2007
| | Posted on Saturday, September 08, 2007 - 10:03 am: |
|
Had a complete rebuild on the Port engine and have never been able o get it running right . The Tech can not figure out the issue, he just keeps throwing parts at it...To the issue. At idle it is running somewhat ruff, when put in gear the engine stalls and dies sometime. Replaced injectors and Idle motor and it will not stall when in gear now, but when you power up it gets to 2400 RPM's and sputters and shuts down to idle speed. Tech says the timming is good but that would be my guess. He did install a new distributor with the rebuild and says you cant install it wrong because it only goes in one way. Any help would be greatly apreciated. |
   
Bondo
Advanced Member Username: bondo
Post Number: 524 Registered: 12-2006

| | Posted on Tuesday, September 25, 2007 - 06:51 pm: |
|
Is it getting the required psi of Gas,..??..??.... Sounds like it's Starving for Fuel......... |
   
Brett S
Member Username: roscoelab
Post Number: 57 Registered: 09-2007
| | Posted on Tuesday, October 02, 2007 - 07:16 am: |
|
it also sounds like it is going into ecm protection if it wont go over 2400rpm, are there any codes when he checks this? |
|
|