|
| Cooling water for PSS Dripless shaft ... |
| Author |
Message |
    
billnetto
Visitor
| | Posted on Wednesday, September 27, 2006 - 11:58 am: | 
|
I have the Marine Power Sportpac 350. I am looking for a location to install a fitting to cool my PSS Dripless shaft seal.
Has anyone done this ? |
Rick Sweeten
Advanced Member
Username: linesix
Post Number: 575
Registered: 11-2002
| | Posted on Wednesday, September 27, 2006 - 06:01 pm: |
|
If it is FWC you can come off of the currently plugged fitting in the bottom of the heat exchanger, if it has one. Make sure you plunge out the port to clear any scale which may be blocking it and flush it good. If RWC, come off of the bottom of the exhaust manifold, same thing goes for flushing this port. |
billnetto
Visitor
| | Posted on Thursday, September 28, 2006 - 07:40 am: |
|
Thanks for the info. It is FWC so I'll use the heat exchanger. |
Rick Sweeten
Advanced Member
Username: linesix
Post Number: 577
Registered: 11-2002
| | Posted on Thursday, September 28, 2006 - 08:11 am: |
|
Bill, Just make sure it's a raw water port, some exchangers have both. |
billnetto
Visitor
| | Posted on Thursday, September 28, 2006 - 11:46 am: |
|
Ok will do. Thanks |
Gary Smith
New member
Username: robbins29
Post Number: 1
Registered: 09-2006
| | Posted on Friday, September 29, 2006 - 07:39 pm: |
|
I had PSS installed recently. The cooling line was run from the starboard drain plug on the forward heat exchanger. Engine temps didn't change. |
|
|
|
Product Categories |
| Engine Parts · By Brand |
| Engine Manuals · By Brand |
| Books |
| General Repair and Maint. |
| Care and Repair |
| · Adhesive and Sealants |
| · Bottom Cleaners |
| · Cleaners Wax and Polish |
| · Mops Brushes and Sponges |
| Covers and Tops |
| · Bimini Tops · Hardware |
| · Cover Accessories |
| · Motor Covers |
| · Universal Boat Covers |
| Electronics |
| · Gauges and Compasses |
| · Mounts and Accessories |
| Electrical |
| · Batteries & Chargers |
| · Battery Accessories |
| · Dockside Electrical |
| · Electrical Terminals |
| · Electrical Wire, Cable |
| · Fuses, Fuse Holders |
| · Switches |
| · Wire Ties, Clips, Tape |
| Fuel Systems |
| · Fuel Tanks |
| · Fittings, Fills, Vents |
| · Hose & Primer Bulbs |
| · Filters, Senders, Caps |
| Hardware |
| · Deck Cabin Hardware |
| · Molding and Rub Rails |
| · Rails and Fittings |
| · Snaps Shackles and Hooks |
| · Windshield Hardware |
| Lighting |
| · Cabin Lights · Light Bulbs |
| · Navigation Light Parts |
| · Navigation Lights |
| · Spotlights · Parts |
| Mooring and Dock |
| · Boat Fenders · Boat Hooks |
| · Buoys and Markers |
| · Deck Cleats · Dock Edging |
| · Dock Parts and De-Icers |
| · Fender Covers and Holders |
| · Keelshield / Toon-Tectors |
| · Ladders and Platforms |
| Prop / Trim /
Transom |
| · Jack Plates, Wedges |
| · Mounting Brackets |
| · Outboard Stands |
| · Trim Tabs, Stablizers |
| · Prop Nuts, Locks, Pins |
| · Propellers · Wrenches |
| Pumps |
| · Aerator Pumps |
| · Bilge Pumps |
| · Drain Plugs and Tubes |
| · Hose · Through Hull Fittings |
| Rope and Cordage |
| · Anchor Line · Dock Line |
| · Fender Line · Bulk Rope |
| · Shock Cord and Bungee |
| Safety Products |
| · Horns Bells and Whistles |
| · Mirrors |
| · Vents Blowers and Hose |
| Sanitation |
| · Fresh Water Pumps |
| · Marine Toilets |
| · Sanitation Chemicals |
| · Sanitation Pumps/Hose |
| · Water/Waste System Parts |
| Seating |
| · Deck Chairs and Tables |
| · Fishing Seats |
| · Lounge Seats |
| · Pontoon Furniture |
| · Seat Bases and Pedestals |
| Steering / Control |
| · Control
Boxes |
| · Control
Cables |
| · Hydraulic
Steering |
| · Mechanical
Steering |
| · Rigging · Steering
Wheels |
| Tools / Shop Supplies |
| · Lubricants & Additives |
| · Motor Flushers |
| · Tools & Test Equipment |
| Trailering |
| · Boat Guides/Motor Support |
| · Hitches Balls Couplers |
| · Rollers Brackets Springs |
| · Tires Wheels and Carriers |
| · Trailer Hubs & Bearings |
| · Trailer Jacks |
| · Trailer Wiring and Lighting |
| · Winches Straps Tie Downs |
| Manufacturer List |
|
