|
| 24 ft Chris-Craft Corsair |
| Author |
Message |
   
David Garbrough
New member Username: dave_garbrough
Post Number: 1 Registered: 03-2009
| | Posted on Tuesday, March 31, 2009 - 10:50 am: |
|
I have a 1967 Chris Craft Corsair Fiberglass Hull made by Thompson. Originally this boat was built with a 283 sbc (Small Block Chevy) Then years later, a 350 sbc was installed. Now, I am ready to repower this boat once again. I have purchased a 454 bbc 350HP crusader(Big Block Chevy)complete with fresh water cooled exhaust manifolds and built it to a 486 cid. I haven't purchased an intake or carb yet. I'm on the fence about installing electronic fuel injection via Multiport injection. Has anyone done this? If so, any ideas where to get a deal on an installation kit? Thanks in advance for your help. DG |
   
Lukey
Member Username: partgypsy
Post Number: 5 Registered: 11-2007
| | Posted on Tuesday, March 31, 2009 - 03:47 pm: |
|
That thing's gonna fly! Everyone I talk to says... multi-port. I'm kicking around putting two 383 strokers in my Catalina, but i'll stick with carbs for now. |
   
Robert A. Fierro
Advanced Member Username: sandkicker
Post Number: 471 Registered: 06-2008
| | Posted on Thursday, April 02, 2009 - 02:10 pm: |
|
I believe that boat came off the line with a Volvo stern drive. IFSO, is that what you are still running? |
|
|