| Author |
Message |
   
Henry G Pelletier
Member Username: cruisers00
Post Number: 21 Registered: 01-2007
| | Posted on Thursday, November 01, 2007 - 04:56 pm: |
|
Is anyone knows where I can get a pair of Carb. Base Gaskets for my Crusader model 350 (7.4L)I need 2 because of the 7 deg. riser plate. (straight shaft) Just rebuilt with an Echlin Carb. rebuilt Kit. Kind of easy to do. |
   
Henry G Pelletier
Member Username: cruisers00
Post Number: 22 Registered: 01-2007
| | Posted on Thursday, November 01, 2007 - 05:02 pm: |
|
The Carburator is a Rochester Quadrajet # 17082403. I have the GM Delco Book on it, very interesting 40 pages. |
   
Chuck Hanson
Member Username: chuckhanson
Post Number: 7 Registered: 10-2007

| | Posted on Saturday, November 03, 2007 - 05:52 am: |
|
Henry, this is the same carburetor that I have. I noticed that the rebuild kit for it is available at MarineEngine.com. I don't know if they just sell the gasket. I had mine rebuilt by Carburetor Specialist - 5715 N, Commerce Court, Suite 200 Alpharetta, GA 30004 678-393-1501. They supplied the gasket for reinstallation. Perhaps you can get the gasket from them. Good Luck Chuck |
   
Henry G Pelletier
Member Username: cruisers00
Post Number: 23 Registered: 01-2007
| | Posted on Saturday, November 03, 2007 - 10:15 am: |
|
Thanks Chuck, I will give them a call. Henry G |
   
Henry G Pelletier
Member Username: cruisers00
Post Number: 24 Registered: 01-2007

| | Posted on Tuesday, November 06, 2007 - 08:28 am: |
|
Gaskets have been ordered Thanks again for your help Henry G. |
   
Henry G Pelletier
Member Username: cruisers00
Post Number: 29 Registered: 01-2007

| | Posted on Tuesday, December 11, 2007 - 08:19 pm: |
|
got the carburator clean and install a new float (copper) in case I get some ethanol in the future. there was an inch of dirt in the bowl, was surprise the engine was still running good except the fuel was dripping on one side under the choke. could see gas slick when idle at the dock coming from the exhaust. Piece of cake to rebuilt a Rochester quadrajet. Will do the other one in the spring. Have a nice winter. Henry G. |
   
Rick Talbott
New member Username: footbutcher
Post Number: 1 Registered: 05-2008
| | Posted on Friday, May 09, 2008 - 05:22 pm: |
|
ENGINE BACKFIRES THRU CARB BETWEEN 1500 TOO 3500 UNDER LOAD 454 ENGINE WITH ROCHESTER QUADRAJET |
   
Al Lombardo
Advanced Member Username: knuckle47
Post Number: 176 Registered: 09-2007

| | Posted on Friday, May 09, 2008 - 05:39 pm: |
|
Rick, Did you check the usual: Plugs cap rotor Wires? When I had a similiar problem, it was a bad cap. |
   
TRT
New member Username: footbutcher
Post Number: 3 Registered: 05-2008
| | Posted on Saturday, May 10, 2008 - 10:08 pm: |
|
yes all new dist wires plugs and coil. |