| Author |
Message |
    
Nathan hinds
New member
Username: natarch519
Post Number: 1
Registered: 09-2009
| | Posted on Monday, September 21, 2009 - 01:45 pm: | 
|
I had the shaft that comes out of the tilt motor break. How in the world do you get the tilt motor off to replace either the shaft or the whole motor?!?!? |
Hy Stat
Senior Member
Username: hystat
Post Number: 1494
Registered: 05-2007
| | Posted on Monday, September 21, 2009 - 01:51 pm: |
|
title of this thread says trim motor, then your posting says tilt.
Which one are you working on? |
Nathan hinds
New member
Username: natarch519
Post Number: 2
Registered: 09-2009
| | Posted on Monday, September 21, 2009 - 01:54 pm: |
|
Yeah I just noticed that. I am trying to remove the tilt motor |
Hy Stat
Senior Member
Username: hystat
Post Number: 1495
Registered: 05-2007
| | Posted on Monday, September 21, 2009 - 10:12 pm: |
|
depends on the year.
earlier units, the two long screws that go right through the motor housing also fasten it to the intermediate.
Later have a flange with 2 bolts.
On some hulls it helps to remove the transom boot. |
