MarineEngine.com - Your best connection for marine engines, parts, service, and information. View Cart / Check Out Contact MarineEngine.com Ordering and Shipping Information Free Engine Classifieds Engine Parts Discussion Board Engine Manuals Home / Directory
add bookmark or favorites | email this page
Topics Topics Edit Profile Profile Help/Instructions Help Member List Register  
Search Last 1|3|7 Days Search Search Tree View Tree View  

280 mechanical tilt

Discussion Forum at MarineEngine.com » Volvo Penta Gas » Archive through February 20, 2008 » 280 mechanical tilt « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Chris
Member
Username: 43_lx_merc_1996

Post Number: 39
Registered: 09-2006
Posted on Friday, January 11, 2008 - 01:21 am:   Edit Post Delete Post View Post/Check IP

The little piston on the outboard side of the leg seems to be seized (the one that pushes down to lift the leg.) The worm gear/motor/etc all seems to be fine otherwise. Any ideas on how to free this up?

THanks,
Top of pagePrevious messageNext messageBottom of page Link to this message

El Pescador
Senior Member
Username: el_pescador

Post Number: 2705
Registered: 02-2006
Posted on Saturday, January 12, 2008 - 01:11 pm:   Edit Post Delete Post View Post/Check IP

The mechanical lift is attached to the transom shield by means of two Allen screws. If you have the boat on a trailer, just remove the screws and pull the whole thing out so that you can either free it or investigate why it is not working.

One note, though: I have noticed that some the mechanical lift devices perform well when the boat is in the water, but have difficulty lifting a leg when the boat has been dry for awhile. While there could be more than one reason for that, remember that the 280 is a heavy leg but (like al objects) it is much lighter while in the water.
Top of pagePrevious messageNext messageBottom of page Link to this message

Chris Wilcox
Visitor
Posted on Monday, February 18, 2008 - 07:11 pm:   Edit Post Delete Post View Post/Check IP

I had a similar problem and found that the Shaft was bent. The previous owner always kept it down a little to keep the reverse latch from catching. When I removed it I found the shaft very bent (3/8" in center) and the bottom of the sleeve to be broken off. I was able to get through the season by bending it straight with a large press. I have a replacement now though.

Chris

Administration Administration Log Out Log Out   Previous Page Previous Page Next Page Next Page


Home / Directory | Engine Manuals | Engine Parts | Discussion Board | Free Classifieds | Orders / Shipping | Contact Us | View Cart

About Us | Terms of Use | Privacy Policy
MarineEngine.com, 184 Jones Dr., Brandon, VT 05733 USA
Phone: 802-247-4700 FAX: 802-301-1034 info@marineengine.com
Copyright © 2000 - 2007 by MarineEngine.com, Inc. All rights reserved
   
Traduca
EspanolEspanol
Traduisez
FrancaisFrancais
Traduza
PortuguesePortuguese
Traduca
Italiano
Ubersetzen
Deutschen
  
Sierra Marine Catalog
Seloc Online Manuals
Product Categories
Engine Parts · By Brand
Engine Manuals · By Brand
Books
General Repair and Maint.
Care and Repair
· Adhesive and Sealants
· Bottom Cleaners
· Cleaners Wax and Polish
· Mops Brushes and Sponges
Covers and Tops
· Bimini Tops   · Hardware
· Cover Accessories
· Motor Covers
· Universal Boat Covers
Electronics
· Gauges and Compasses
· Mounts and Accessories
Electrical
· Batteries & Chargers
· Battery Accessories
· Dockside Electrical
· Electrical Terminals
· Electrical Wire, Cable
· Fuses, Fuse Holders
· Switches
· Wire Ties, Clips, Tape
Fuel Systems
· Fuel Tanks
· Fittings, Fills, Vents
· Hose & Primer Bulbs
· Filters, Senders, Caps
Hardware
· Deck Cabin Hardware
· Molding and Rub Rails
· Rails and Fittings
· Snaps Shackles and Hooks
· Windshield Hardware
Lighting
· Cabin Lights · Light Bulbs
· Navigation Light Parts
· Navigation Lights
· Spotlights   · Parts
Mooring and Dock
· Boat Fenders · Boat Hooks
· Buoys and Markers
· Deck Cleats · Dock Edging
· Dock Parts and De-Icers
· Fender Covers and Holders
· Keelshield / Toon-Tectors
· Ladders and Platforms
Prop / Trim / Transom
· Jack Plates, Wedges
· Mounting Brackets
· Outboard Stands
· Trim Tabs, Stablizers
· Prop Nuts, Locks, Pins
 · Propellers · Wrenches
Pumps
· Aerator Pumps
· Bilge Pumps
· Drain Plugs and Tubes
· Hose · Through Hull Fittings
Rope and Cordage
· Anchor Line   · Dock Line
· Fender Line   · Bulk Rope
· Shock Cord and Bungee
Safety Products
· Horns Bells and Whistles
· Mirrors
· Vents Blowers and Hose
Sanitation
· Fresh Water Pumps
· Marine Toilets
· Sanitation Chemicals
· Sanitation Pumps/Hose
· Water/Waste System Parts
Seating
· Deck Chairs and Tables
· Fishing Seats
· Lounge Seats
· Pontoon Furniture
· Seat Bases and Pedestals
Steering / Control
· Control Boxes
· Control Cables
· Hydraulic Steering
· Mechanical Steering
· Rigging · Steering Wheels
Tools / Shop Supplies
· Lubricants & Additives
· Motor Flushers
· Tools & Test Equipment
Trailering
· Boat Guides/Motor Support
· Hitches Balls Couplers
· Rollers Brackets Springs
· Tires Wheels and Carriers
· Trailer Hubs & Bearings
· Trailer Jacks
· Trailer Wiring and Lighting
· Winches Straps Tie Downs
 Manufacturer List