| Author |
Message |
    
Seid
Visitor
| | Posted on Wednesday, April 30, 2008 - 02:25 pm: | 
|
I bought new manifolds and elbows to replace my old ones.
The old manifold (osco) had two sacrificial anodes (pencil zinc), but the new one doesn't have a spot for it, other then drain plugs on the bottom.
Anyone? |
Bondo
Advanced Member
Username: bondo
Post Number: 970
Registered: 12-2006
| | Posted on Thursday, May 01, 2008 - 06:42 pm: |
|
Ayuh,.....
I can't help ya with your anode issue,....
None of My manifolds have had them,....
But,... Just alittle FYI,....
If those Seirra manifolds are GLM copies,....
Check the gasket mating surface,....
Mine were Out by about .010"....
I had to mill them Flat.... |
|
