|
| Author |
Message |
    
scott mcculloch
New member
Username: scott79
Post Number: 1
Registered: 10-2009
| | Posted on Monday, October 19, 2009 - 08:41 am: | 
|
I have a Honda 90hp 4 stroke that was not pumping water very good. I change the impeller, key and gasket then refit. It still pumps in a steady stream but not as strong as the stb engine. |
W D Neal
Advanced Member
Username: chawk_man
Post Number: 249
Registered: 09-2008
| | Posted on Monday, October 19, 2009 - 10:01 am: |
|
Immediate thoughts - assuming the impeller & gaskets installed properly. Any pieces missing from old impeller? If so, reverse flush and try to get them out. Remove & clean pee tube & check fittings. Remove T-Stats and clean & test thoroughly. Flush with Salt Away (even if you are running in fresh water - can still get calcium build up.) |
JUST-IN-TIME
Senior Member
Username: justintime
Post Number: 6983
Registered: 09-2006
| | Posted on Wednesday, October 21, 2009 - 09:34 pm: |
|
clean the pee hole out |
|
|
