| Author |
Message |
    
Paul Graham
Member
Username: pagraham
Post Number: 22
Registered: 06-2008
| | Posted on Saturday, September 26, 2009 - 09:13 pm: | 
|
My steering is stiff, I disconnected the steering arm from the teleflex cable and have determined it is the steering pivot tube on the motor. I have forced as much grease as I can by wrapping the bottom of the tube with gasket material and a hose clamp where it joins the lower unit, this is where grease normally oozes out when you pump it full of grease. No grease comes out at the top of the tube, any ideas on how I can force grease up to the top of the tube? |
JUST-IN-TIME
Senior Member
Username: justintime
Post Number: 6974
Registered: 09-2006
| | Posted on Wednesday, October 14, 2009 - 02:58 am: |
|
buy the grease rejenator from harbor freight |
Paul Graham
Member
Username: pagraham
Post Number: 29
Registered: 06-2008
| | Posted on Wednesday, October 14, 2009 - 02:30 pm: |
|
just in, what is the correct word, harbr freight does not recognize the word "rejenator", thanks |
mike
Advanced Member
Username: hondadude
Post Number: 189
Registered: 03-2009
| | Posted on Wednesday, October 14, 2009 - 08:16 pm: |
|
I think the correct spelling is rejuvenator. |
Paul Graham
Member
Username: pagraham
Post Number: 30
Registered: 06-2008
| | Posted on Thursday, October 15, 2009 - 10:40 pm: |
|
I see these now on the internet. So you think it will really push out that old hard grease? |
