|
| Author |
Message |
    
Oscar Ansley
Member
Username: bass_tracker
Post Number: 19
Registered: 11-2008
| | Posted on Saturday, November 14, 2009 - 03:13 pm: | 
|
getting water in the bottom Cyl. the shop has replaced the head gasket and pulled the power head and replace the base gaskets and the manifold gasket. but say that water is still getting in and can't find out where it getting in. is there some other place it can get in are did they just want to sell my bro-in-law the new motor thay sold him? it only skips when you take off and after a little bit it will leval out than runs good untill you stop and fish. |
JUST-IN-TIME
Senior Member
Username: justintime
Post Number: 7092
Registered: 09-2006
| | Posted on Sunday, November 15, 2009 - 02:42 am: |
|
cracked block |
|
|
