| Author |
Message |
    
lee d
New member
Username: o0wizard0o
Post Number: 1
Registered: 11-2009
| | Posted on Monday, November 16, 2009 - 02:12 pm: | 
|
i have a dell quay dory with mariner outboard, need impeller, all i can see on engine cradle is 676b 40718, and on engine itself"67602" also y-1 ? means nothing to me, any help on year etc and where to find impeller, much appreciated |
ian summerfield
Member
Username: budgie14
Post Number: 76
Registered: 06-2009
| | Posted on Monday, November 16, 2009 - 02:51 pm: |
|
Hi Lee,i get 1979-80 yamaha based mariner 40hp?.yamaha agents may have parts |
Noel McBride
Advanced Member
Username: haventaclue
Post Number: 347
Registered: 05-2007
| | Posted on Monday, November 16, 2009 - 02:53 pm: |
|
Hi lee,
That number, 676B 40718, would make it a 1980,that is if it was a 40EL . So you need to post the HP.The one thing is sure is that it is a yamaha built mariner.If Graham is looking in he will be able to give you the yamaha equivalent,he's the mariner expert. |
lee d
New member
Username: o0wizard0o
Post Number: 2
Registered: 11-2009
| | Posted on Monday, November 16, 2009 - 05:38 pm: |
|
great, thanks a lot |
lee d
New member
Username: o0wizard0o
Post Number: 3
Registered: 11-2009
| | Posted on Tuesday, November 17, 2009 - 01:10 pm: |
|
its a 40hp |
Noel McBride
Advanced Member
Username: haventaclue
Post Number: 351
Registered: 05-2007
| | Posted on Tuesday, November 17, 2009 - 02:58 pm: |
|
AS Ian says take the impeller to a yamaha shop and they may have one,mid 70's yamaha 40hp. |
lee d
Member
Username: o0wizard0o
Post Number: 5
Registered: 11-2009
| | Posted on Tuesday, November 17, 2009 - 03:00 pm: |
|
will it be the impeller?, its been stood around 18 month, no water trickles out of hole~? |
ian summerfield
Member
Username: budgie14
Post Number: 77
Registered: 06-2009
| | Posted on Tuesday, November 17, 2009 - 03:55 pm: |
|
hi,i put electric drill onto driveshaft,with g/box submerged in bucket of water,and fire it up and see how much water flow/presure comes out hole where pipe normally goes in.make sure its in nuetral,and that the intake is submerged.saves assembling/starting/diassembling.that will tell you if impellor is worn or not.they should be clean/firm but flexible.no bits missing |
ian summerfield
Member
Username: budgie14
Post Number: 78
Registered: 06-2009
| | Posted on Tuesday, November 17, 2009 - 03:57 pm: |
|
forgot to say,take g/box off first.helps |
