|
| Author |
Message |
    
tom
Member
Username: floridakeys
Post Number: 5
Registered: 07-2006
| | Posted on Wednesday, November 04, 2009 - 04:55 pm: | 
|
no spark at coils, found one voltage reg.bad, still no spark, exchanged control module and ecu with running twin, still no fire, ohm readings for stator looked ok but trigger readings were not according to manual but read about the same as the running, any ideas
thanks tomkat |
Richy
Member
Username: jiggamurf
Post Number: 29
Registered: 08-2009
| | Posted on Wednesday, November 04, 2009 - 05:31 pm: |
|
did you check your kill switch circuit? |
JUST-IN-TIME
Senior Member
Username: justintime
Post Number: 7053
Registered: 09-2006
| | Posted on Tuesday, November 10, 2009 - 05:23 am: |
|
use volts with a dva
is this the CDM motor |
|
|
