|
| Author |
Message |
   
scotty cannella
Member Username: bigdog86
Post Number: 26 Registered: 06-2009
| | Posted on Thursday, July 02, 2009 - 12:44 am: |
|
hi i was wourding should i switch from a 4 blade prop to a 3 blade prop will it make the motor run any better i have an 87 mariner 150 magnum will it take any stran off the motor whats the diff as in what is a 4 blade good for vs a 3 blade |
   
Fastjeff
Senior Member Username: fastjeff
Post Number: 6179 Registered: 09-2003

| | Posted on Thursday, July 02, 2009 - 06:06 am: |
|
About 500 bucks missing from your walet! Jeff |
   
scotty cannella
Member Username: bigdog86
Post Number: 27 Registered: 06-2009
| | Posted on Thursday, July 02, 2009 - 12:40 pm: |
|
well i have a 4 blade on it right is there any reson i should switch to a 3 blade |
   
Graham Lamb
Senior Member Username: galamb
Post Number: 5527 Registered: 05-2007

| | Posted on Thursday, July 02, 2009 - 01:06 pm: |
|
The two styles serve different puroposes, so it depends how you use the boat. A 3 blade will ultimately give you better top end performance - not so much that you will really notice, but could see a couple more mph at wide open. The 4 blade will get you out of the hole faster, get you on plane sooner and keep you there at a lower speed than a 3 blade will. So if you use the boat to tow ski's, tubes, boards or do alot of cruising or travel distances in "no wake" or reduced speed areas (canals etc), then the 4 blade is the better choice. For just general "horsing around", the 3 blade can be considered a "standard" prop. Since you are running a 4 blade you would normally move up in pitch by 1" going to a 3 blade of similar characteristics (same diameter, same material ie. stainless, or whatever, cupped or not cupped). However, if you were running say a 19 pitch 4 blade aluminum (non cupped) moving the a 3 blade stainless would probably stay at 19 pitch since the stainless flexs a little less/bites a little harder than aluminum or composite. Selecting a prop is a bit of trial and error with a little bit of science thrown in... |
   
scotty cannella
Member Username: bigdog86
Post Number: 28 Registered: 06-2009
| | Posted on Thursday, July 02, 2009 - 01:52 pm: |
|
thank u so much |
|
|
|
Product Categories |
| Engine Parts · By Brand |
| Engine Manuals · By Brand |
| Books |
| General Repair and Maint. |
| Care and Repair |
| · Adhesive and Sealants |
| · Bottom Cleaners |
| · Cleaners Wax and Polish |
| · Mops Brushes and Sponges |
| Covers and Tops |
| · Bimini Tops · Hardware |
| · Cover Accessories |
| · Motor Covers |
| · Universal Boat Covers |
| Electronics |
| · Gauges and Compasses |
| · Mounts and Accessories |
| Electrical |
| · Batteries & Chargers |
| · Battery Accessories |
| · Dockside Electrical |
| · Electrical Terminals |
| · Electrical Wire, Cable |
| · Fuses, Fuse Holders |
| · Switches |
| · Wire Ties, Clips, Tape |
| Fuel Systems |
| · Fuel Tanks |
| · Fittings, Fills, Vents |
| · Hose & Primer Bulbs |
| · Filters, Senders, Caps |
| Hardware |
| · Deck Cabin Hardware |
| · Molding and Rub Rails |
| · Rails and Fittings |
| · Snaps Shackles and Hooks |
| · Windshield Hardware |
| Lighting |
| · Cabin Lights · Light Bulbs |
| · Navigation Light Parts |
| · Navigation Lights |
| · Spotlights · Parts |
| Mooring and Dock |
| · Boat Fenders · Boat Hooks |
| · Buoys and Markers |
| · Deck Cleats · Dock Edging |
| · Dock Parts and De-Icers |
| · Fender Covers and Holders |
| · Keelshield / Toon-Tectors |
| · Ladders and Platforms |
| Prop / Trim /
Transom |
| · Jack Plates, Wedges |
| · Mounting Brackets |
| · Outboard Stands |
| · Trim Tabs, Stablizers |
| · Prop Nuts, Locks, Pins |
| · Propellers · Wrenches |
| Pumps |
| · Aerator Pumps |
| · Bilge Pumps |
| · Drain Plugs and Tubes |
| · Hose · Through Hull Fittings |
| Rope and Cordage |
| · Anchor Line · Dock Line |
| · Fender Line · Bulk Rope |
| · Shock Cord and Bungee |
| Safety Products |
| · Horns Bells and Whistles |
| · Mirrors |
| · Vents Blowers and Hose |
| Sanitation |
| · Fresh Water Pumps |
| · Marine Toilets |
| · Sanitation Chemicals |
| · Sanitation Pumps/Hose |
| · Water/Waste System Parts |
| Seating |
| · Deck Chairs and Tables |
| · Fishing Seats |
| · Lounge Seats |
| · Pontoon Furniture |
| · Seat Bases and Pedestals |
| Steering / Control |
| · Control
Boxes |
| · Control
Cables |
| · Hydraulic
Steering |
| · Mechanical
Steering |
| · Rigging · Steering
Wheels |
| Tools / Shop Supplies |
| · Lubricants & Additives |
| · Motor Flushers |
| · Tools & Test Equipment |
| Trailering |
| · Boat Guides/Motor Support |
| · Hitches Balls Couplers |
| · Rollers Brackets Springs |
| · Tires Wheels and Carriers |
| · Trailer Hubs & Bearings |
| · Trailer Jacks |
| · Trailer Wiring and Lighting |
| · Winches Straps Tie Downs |
| Manufacturer List |
|