|
| Need Johnson Std 3" Piston assembly |
| Author |
Message |
    
David Maybury
Member
Username: davenaus
Post Number: 23
Registered: 08-2009
| | Posted on Tuesday, November 03, 2009 - 03:47 pm: | 
|
Looking for a fully assembled and used standard size (3") piston assembly with connecting rod (320953), screws, etc minus rings. Engine J70ELCSA; 1980 70 Hp, Johnson, plus shipping cost to Coffs Harbour, NSW, Australia 2450. |
jwbmarine
Senior Member
Username: jwbmarine
Post Number: 5083
Registered: 11-2005
| | Posted on Tuesday, November 03, 2009 - 04:15 pm: |
|
here ----email this fellow,..he has alot of parts------> joe reeves
ReevesJ32@aol.com |
Richard
Member
Username: rude70
Post Number: 54
Registered: 03-2006
| | Posted on Friday, November 06, 2009 - 05:46 am: |
|
I live in Vic, I recently re-built a 1977 70HP, you would be bettor off getting a new piston/ring set & small end bearings. I used GLM parts the wrist pin was relatively easy to push in by hand. There are many dealers about, try Robinson Marine in Southport QLD - he posts parts has new & second hand. |
David Maybury
Member
Username: davenaus
Post Number: 24
Registered: 08-2009
| | Posted on Friday, November 06, 2009 - 03:32 pm: |
|
Thanks for all the advice. I found a good condition used piston here in Australia but will always consider Mr. Reeves. He was very kind and generous with his offer. |
|
|
