| Author |
Message |
    
Mustafa Abdelwahab
New member
Username: mustafawahab
Post Number: 1
Registered: 07-2009
| | Posted on Monday, July 20, 2009 - 02:05 am: | 
|
Where can I buy a replacement tilt pin for 1985 Evinrude outboard model E25ELCOC. What is the part number? |
Joe Reeves
Senior Member
Username: joereeves
Post Number: 7700
Registered: 02-2001
| | Posted on Monday, July 20, 2009 - 08:53 am: |
|
That pin may be available on this site. See icon at top of page (Engine Parts).
If not, any dealership would be able to supply that pin.
Original part number is 391271, superseded up to 436387. |
Mustafa Abdelwahab
New member
Username: mustafawahab
Post Number: 2
Registered: 07-2009
| | Posted on Monday, July 20, 2009 - 11:39 pm: |
|
Thank you Joe.
Do you know the part number for the angle adjusting rod assembly for the 1985 Evinrude outboard model E25ELCOC? |
Joe Reeves
Senior Member
Username: joereeves
Post Number: 7706
Registered: 02-2001
| | Posted on Monday, July 20, 2009 - 11:50 pm: |
|
Whoa! The part number I supplied IS for the "angle adjusting rod" that inserts thru the lower holes in the transom brackets which is normally referred to as a tilt pin.
In your first post above, the replacement tilt pin mentioned..... are you speaking of the pin/bolt/tube (whichever it may be) that secures the two transom brackets together, that the engine actually tilts on?
Thousands of parts in my remaining stock. Not able to list them all. Let me know what you need and I'll look it up for you. Visit my eBay store at:
http://stores.ebay.com/Evinrude-Johnson-Outboard-Parts-etc?refid=store |
