| Author |
Message |
    
Frankie Sheats
New member
Username: noel1955
Post Number: 1
Registered: 07-2009
| | Posted on Saturday, July 11, 2009 - 02:41 pm: | 
|
on a fas trak trim/tilt assembly. on the piston assembly I have 2 size springs and 2 size holes (on bottom of piston). the springs will fit in all holes on top of piston. can you tell me which size springs
(long or short) match the size of holes (small or large) |
jwbmarine
Senior Member
Username: jwbmarine
Post Number: 4660
Registered: 11-2005
| | Posted on Tuesday, July 14, 2009 - 08:20 pm: |
|
u will need a factory service manual,for proper placement,unless,u got lucky... |
Frankie Sheats
New member
Username: noel1955
Post Number: 2
Registered: 07-2009
| | Posted on Wednesday, July 15, 2009 - 01:34 am: |
|
I had bought a seloc johnson/evinrude 1992-01 repair manuel from iboats.com which goes into great detail but does not answer my question. isbn--13: 978-0-89330-063-0
10: 0-89330-063-2 is the factory manuel different from this? thanks |
jwbmarine
Senior Member
Username: jwbmarine
Post Number: 4661
Registered: 11-2005
| | Posted on Wednesday, July 15, 2009 - 07:00 am: |
|
yep........if it does not show exact placement,it will say to repl entire end piece. |
