|
| Late 90's 155hp overheating???? x 2 ... |
| Author |
Message |
    
Ray Edwards
New member
Username: 210fireman
Post Number: 2
Registered: 06-2009
| | Posted on Tuesday, June 30, 2009 - 09:55 pm: | 
|
O.k. , I wrote to ask about this and heard from someone else that said the engines may be to high out of the water causing them to suck air instead of water . I had someone look at the motors at 4000 rpm and the top holes are out of the water . They told me to plug them off and see if it cures it . If it does , they said to epoxy them closed.Any Ideas on this ??I cannot get them over 4000 rpm without them showing hot and then not running right until they cool . They do both put out allot of water where they are suppose to . Help . |
Morten Ringvold
Senior Member
Username: haffiman37
Post Number: 3859
Registered: 04-2006
| | Posted on Tuesday, June 30, 2009 - 10:15 pm: |
|
Do You have a pick showing engine installation heights?
Are there any steps disturbing the water flow to the engines? |
|
|
