| Author |
Message |
    
Gary Jackman
Member
Username: gjackman
Post Number: 19
Registered: 05-2008
| | Posted on Monday, June 29, 2009 - 10:53 am: | 
|
I would like to install a temp gauge in my dash for my motor. Any ideas where I can install the sending unit on the engine. ie: exhaust cover plate.
Any help, suggestions are appreciated. |
jwbmarine
Senior Member
Username: jwbmarine
Post Number: 4538
Registered: 11-2005
| | Posted on Monday, June 29, 2009 - 12:32 pm: |
|
inst on cyl hd...clean off paint,inst a snug fit,to hd. |
Gary Jackman
Member
Username: gjackman
Post Number: 20
Registered: 05-2008
| | Posted on Monday, June 29, 2009 - 01:03 pm: |
|
do i have to drill and tap it into the head (if so where is a good spot) or just make sure it is contacting the outside head area? |
jwbmarine
Senior Member
Username: jwbmarine
Post Number: 4542
Registered: 11-2005
| | Posted on Monday, June 29, 2009 - 01:53 pm: |
|
no drilling...u use a hd bolt or cvr bolt to secure most temp senders. |
Gary Jackman
Member
Username: gjackman
Post Number: 21
Registered: 05-2008
| | Posted on Monday, June 29, 2009 - 02:43 pm: |
|
Thanks, I'll give it a try |
