| Author |
Message |
    
ted walker
Member
Username: ted
Post Number: 77
Registered: 01-2006
| | Posted on Saturday, May 17, 2008 - 08:11 pm: | 
|
no water pumping after new pump...replaced with sierra full kit,droped the lower unit 3 times to inspect,impeller is keyed and can see it spinning through water exit hole,followed instructions,have enouf space to see pipe is going into pump,removed stats and water flowed when put hose on pipe,water flows to base of pump with muffs. what am I missing...THANKS |
pops86
Visitor
| | Posted on Saturday, May 17, 2008 - 10:12 pm: |
|
Did you make sure that the water tube going up to the power head is clear?? Many times pieces of the old impeller will be pushed up the tube clogging it. Hope this helps. |
ted walker
Member
Username: ted
Post Number: 78
Registered: 01-2006
| | Posted on Saturday, May 17, 2008 - 10:16 pm: |
|
Its clear,last impeller was still in good shape, |
jwbmarine
Senior Member
Username: jwbmarine
Post Number: 1549
Registered: 11-2005
| | Posted on Sunday, May 18, 2008 - 09:14 am: |
|
inst rubber bushing in pump hsng?,..your prob is w/pump kit.due to your testing of wtr tube and garden hose.-----"removed stats and water flowed when put hose on pipe,water flows to base of pump with muffs"---- see of u can shift and that prop is spinning next time...indicating,that drive shaft is in fact,turning. |
ted walker
Member
Username: ted
Post Number: 79
Registered: 01-2006
| | Posted on Sunday, May 18, 2008 - 06:07 pm: |
|
thanks JWB,found out today sierra makes 2 pumps for my motor,20 and 25 shaft,I had the short shaft pump witch has a hole drilled in the top of the housing,outher then that the housing is the same,(I have the 25 motor)hope that it, |
|
