Starwarrior
New member
Howdy Folks,
My gauges went out on my Command Link and I'm just about to deep 6 the sucker. (Three Round digital Gauges Speed Fuel/tach/tach)
It seems I've lost communications to both engines. No tachometers, No trim level reading, No fuel economy, temp or voltage are displayed.
Both engines start and run fine, the tilt /trim and fuel gauge is working.
Gauges start up and seem to go through normal start up procedures
however then, nothing but dashes .
Many forum threads seem to have identified similar circumstances but all fall short of the answer.
I replaced all three gauges with a used set I found on E-bay and traced and buzzed out every wire I could find.
I am guessing that the CPU Module may be the culprit but...Both of them???
A little advice would be greatly appreciated.
Regards, Starwarrior >)))'> >)))'> >)))'>
My gauges went out on my Command Link and I'm just about to deep 6 the sucker. (Three Round digital Gauges Speed Fuel/tach/tach)
It seems I've lost communications to both engines. No tachometers, No trim level reading, No fuel economy, temp or voltage are displayed.
Both engines start and run fine, the tilt /trim and fuel gauge is working.
Gauges start up and seem to go through normal start up procedures
however then, nothing but dashes .
Many forum threads seem to have identified similar circumstances but all fall short of the answer.
I replaced all three gauges with a used set I found on E-bay and traced and buzzed out every wire I could find.
I am guessing that the CPU Module may be the culprit but...Both of them???
A little advice would be greatly appreciated.
Regards, Starwarrior >)))'> >)))'> >)))'>