Carlasdaddy
Contributing Member
I have a 1958 Evinrude 7.5hp that I'm working on. I can't remove the flywheel. I am using a 3-jaw puller and have the 1/4-20 bolts threaded in as far as they will go without interfering with anything below them. I even tried a piece of pipe on the breaker bar and socket, but the center screw on the puller acts like it's bottomed out or something. I tried hitting the sides of flywheel with a dead-blow hammer, but that didn't work either. Anybody got any suggestions on where to go from here?