I am replaceing my 290 SP with a DuoProp and understand that I need to achive a negative/neutral load on the intermediate bearing.
My A measurement is .316 and my B measurement = .313. If I understand past posts correctly this leaves a .003 POSITIVE load on the intermediate bearing which is greater than the recommended tolerance
Is there a remedy or do I just seal up as is and everything should be okay?
My A measurement is .316 and my B measurement = .313. If I understand past posts correctly this leaves a .003 POSITIVE load on the intermediate bearing which is greater than the recommended tolerance
Is there a remedy or do I just seal up as is and everything should be okay?