I am making a lifting lug for this outboard and need to know the exact spacing dimension of the 3 threaded holes on top of the flywheel to make this happen.
Yes, I can easily remove FW and create a template, but it will cost me another $150 to get it torqued back up by the boat dealer. I don't want to go down this path.
I measure 60mm center to center spacing, but accuracy is not guaranteed.
I also measure 35mm from crankshaft center to center of the 3 threaded holes, but again I cannot guarantee accuracy.
Anyone have a catalogued dimension of these holes to validate my measurements for this motor??
Cameron
Yes, I can easily remove FW and create a template, but it will cost me another $150 to get it torqued back up by the boat dealer. I don't want to go down this path.
I measure 60mm center to center spacing, but accuracy is not guaranteed.
I also measure 35mm from crankshaft center to center of the 3 threaded holes, but again I cannot guarantee accuracy.
Anyone have a catalogued dimension of these holes to validate my measurements for this motor??
Cameron