tthomp1334
Contributing Member
bought a 4.3 v6 complete unassembled engine.
all went good until I installed the pistons
Gaped the rings and when I installed the piston the engine got tight.
All rod bearing are .002
I have only installed 5 pistons and when I do I have to drive them down with a rubber mallet. Can not lust push them as I have seen videos
starter will not turn engine over. I do it with a long bar on the front balancer.
Thanks
all went good until I installed the pistons
Gaped the rings and when I installed the piston the engine got tight.
All rod bearing are .002
I have only installed 5 pistons and when I do I have to drive them down with a rubber mallet. Can not lust push them as I have seen videos
starter will not turn engine over. I do it with a long bar on the front balancer.
Thanks