I am looking for a picture or drawing that shows how the tiny carb float spring is installed
The parts diagrams show it mounted on the float pin but it isn’t clear how it pushes or pulls on the float
I have read elsewhere that it isn’t required but currently about half the time my motor starts then stalls after a minute or so with no fuel in the bowl, I assume because the float is stuck in the up position after sitting for any length of time. If I remove the bowl and jiggle the float the motor runs perfectly all day even with multiple stops and starts.
The parts diagrams show it mounted on the float pin but it isn’t clear how it pushes or pulls on the float
I have read elsewhere that it isn’t required but currently about half the time my motor starts then stalls after a minute or so with no fuel in the bowl, I assume because the float is stuck in the up position after sitting for any length of time. If I remove the bowl and jiggle the float the motor runs perfectly all day even with multiple stops and starts.