I have a 1994 Evinrude 70 that appears to have a bad or non-functioning Primer solenoid.
It looks like it's been replaced and looks clean and in good condition.
Is there a way to test this before ordering a new one? Or is this fairly simple to rebuild/clean?
The engine starts almost every time, but occasionally when cold will not start. I was shown how to manually turn it to enable to choke and once it starts, its usually good.
When i push to key to choke, I cannot hear any clicking or any type of activation (not sure if that would be normal anyway)
I am pretty sure the part is 5007356
Any advice would be much appreciated.
It looks like it's been replaced and looks clean and in good condition.
Is there a way to test this before ordering a new one? Or is this fairly simple to rebuild/clean?
The engine starts almost every time, but occasionally when cold will not start. I was shown how to manually turn it to enable to choke and once it starts, its usually good.
When i push to key to choke, I cannot hear any clicking or any type of activation (not sure if that would be normal anyway)
I am pretty sure the part is 5007356
Any advice would be much appreciated.