Morning, I need some guidance. I have a lean sneeze during idle in water and at idle speed in gear. Below is what I’ve done thus far.
Rebuilt all 6 carbs with OE kits did not use nylon washer. Made sure all 3 orifice per carb were clean and clear.
Took the carbs back apart 4 times to verify float level, and float drop. I set them all at 22mm.
Flushed all ports with isopropyl
Replaced all 6 carb bowls
Replaced fuel filter and gaskets
Replaced Spark plugs
Checked all gaskets at manifold and carbs with starting fluid, carb and choke cleaner, and LP gas unable to locate any type of vacuum leak.
Thermostat on order
disconnected pickup tube in gas tank to verify no cracks and solid fuel up to fuel pump.
Today will be putting a vacuum tester on fuel pump to ensure pump is good.
My next step is scheduling the local shop to do a complete link sync to verify timing.
is there something I’m missing or something else I should/could check?
Rebuilt all 6 carbs with OE kits did not use nylon washer. Made sure all 3 orifice per carb were clean and clear.
Took the carbs back apart 4 times to verify float level, and float drop. I set them all at 22mm.
Flushed all ports with isopropyl
Replaced all 6 carb bowls
Replaced fuel filter and gaskets
Replaced Spark plugs
Checked all gaskets at manifold and carbs with starting fluid, carb and choke cleaner, and LP gas unable to locate any type of vacuum leak.
Thermostat on order
disconnected pickup tube in gas tank to verify no cracks and solid fuel up to fuel pump.
Today will be putting a vacuum tester on fuel pump to ensure pump is good.
My next step is scheduling the local shop to do a complete link sync to verify timing.
is there something I’m missing or something else I should/could check?