drobertsobx
Member
Hi,
I'm getting ready to install the power head back on my motor.
Instructions say to install to exhaust housing and torque according to
chart 1/2 then 3/4 then full torque.
Can anybody confirm or correct the torque for the studs and bolts to be:
Chart lists:
96-120 inch pounds (Listed as Crank Case head bolt) in the Seloc Manual.
I was going to use the Cylinder Head bolt pattern... 2 center bolts... then two rear bolts
then front 2 bolts... then rear studs... then front studs... then front bolts.
First timer just want to get it right.
Thanks in advance Don
I'm getting ready to install the power head back on my motor.
Instructions say to install to exhaust housing and torque according to
chart 1/2 then 3/4 then full torque.
Can anybody confirm or correct the torque for the studs and bolts to be:
Chart lists:
96-120 inch pounds (Listed as Crank Case head bolt) in the Seloc Manual.
I was going to use the Cylinder Head bolt pattern... 2 center bolts... then two rear bolts
then front 2 bolts... then rear studs... then front studs... then front bolts.
First timer just want to get it right.
Thanks in advance Don