After the motor sits for a while in order to start I have to pull the plugs and prime with some gas then fires right up.
Runs smooth and restarts with one pull. After sitting for more than a couple of hours then same prime issue.
New plugs are in place. New gas and bulb pumps up tight.
Obviously not getting gas and after sitting gas drains out. How can it not draw gas after 2 or 3 pulls but draws once started.
Any ideas?
Runs smooth and restarts with one pull. After sitting for more than a couple of hours then same prime issue.
New plugs are in place. New gas and bulb pumps up tight.
Obviously not getting gas and after sitting gas drains out. How can it not draw gas after 2 or 3 pulls but draws once started.
Any ideas?