wellcraft 233
New member
from stop, goes into gear fine, rev to 2000 rpm, then revs high but no prop spin? thinking maybe prop rubber letting go/ any ideas, leg and gears seem lovely...thx wellcraft
MarineEngine.com does not offer troubleshooting assistance or repair advice by email or by telephone.
You are invited to join our public Boat Repair Forum to seek assistance from other members.
You may also visit the Boat Motor Manuals section of our site to obtain a service manual.
rubber hub on eng coupler? the shaft from motor to prop is all gears.runs great out of the hole till 2000rpm.doesnt the leg shaft connect solidly to the flywheel(crankshaft)?and if there is a rubber coupler there wouldnt it just spin even on idle? thx wellcraftIf not your prop, you could have spun the rubber hub on the engine coupler.
props coming off in the am..we'll see ? but if looks ok? try a demo i guess. wierd that it would stay together till around 2000rpm. its a stainless with manufacturer pressed rubber with copper sleeve, not a removeable hard plastic collar..???????? first ive come across in 20+ yrs......try yr spare prop,c what happens
doesnt the leg shaft connect solidly to the flywheel(crankshaft)