Logo

AQ 290 280 Installation Alignment

mike77cj

Regular Contributor
"I recently removed the engine

"I recently removed the engine, drive and transom shield from my boat to replace the stringers. Soon I will be ready to re-install the engine.

How do I line up the engine / intermidiate housing so I know where to set my motor mounts and correctly adjust them?

Does anyone know of a website depicting this info?

Thanks"
 
"One precaution I took before

"One precaution I took before I installed a new transom, new mount blocks and a new engine was to measure the distance between the crankshaft bolt in the front engine pulley and the bilge. If you did not go that way, one thing you can do is to install the bellhousing in the transom shield without the engine attached and measure the distance between the primary shaft center and the bilge, then keep that same distance between the crankshaft bolt and the bilge."
 
Back
Top