"I've been fighting aligni
"I've been fighting aligning this sum' bee all night. I can get the alignment tool into to gumble and back out but its VERY tight...not 'freely' like the manual says. It turns pretty easy but again is tight in and out.
Who here has experience aligning these engines? Is it usually tight like this or do i have other issues? I used the manual suggestions...drop the engine in, install rear bolts, torque down, raise/lower with hoist until engine is aligned/tool moves in/out, tighten front mount, release hoist, check alignment tool, re-adjust if needed...
It seems to hold the same resistance before/after release the hoist and adjust it."
"I've been fighting aligning this sum' bee all night. I can get the alignment tool into to gumble and back out but its VERY tight...not 'freely' like the manual says. It turns pretty easy but again is tight in and out.
Who here has experience aligning these engines? Is it usually tight like this or do i have other issues? I used the manual suggestions...drop the engine in, install rear bolts, torque down, raise/lower with hoist until engine is aligned/tool moves in/out, tighten front mount, release hoist, check alignment tool, re-adjust if needed...
It seems to hold the same resistance before/after release the hoist and adjust it."