" I just got finished replacin
" I just got finished replacing the wiring in the tiller arm, and everything went great until we were out on the water and all of a sudden the motor cut off at WOT. I figured it was something electrical, but the motor fired back up. It ran fine, but would not go above about 2800 rpms. I think I found the problem, the throttle cam is not picking up the cam follower roller. It looks as if it just slipped off. If anyone hazs any ideas, I'd appreciate it.
J.D. "
" I just got finished replacing the wiring in the tiller arm, and everything went great until we were out on the water and all of a sudden the motor cut off at WOT. I figured it was something electrical, but the motor fired back up. It ran fine, but would not go above about 2800 rpms. I think I found the problem, the throttle cam is not picking up the cam follower roller. It looks as if it just slipped off. If anyone hazs any ideas, I'd appreciate it.
J.D. "